Post
by Rob5 » Sat Jan 11, 2014 5:29 pm
Recently installed the same kit. I just undid all the interior lights and put the bulbs in the slots they fit into. Bear in mind that they have to be put in the right way round unlike conventional bulbs which light either way. If it doesn't work, spin it round.
From memory:
Bottom right - Interior boot lid lamps
Top right large flat - Interior front and rear centre roof lights (centre lamp)
Top right small round - Wing mirror downlighters
Top middle - Interior front and rear centre roof lights (map lights, same unit as above)
All the others fit into footwells, doors and numberplate. They are all different lengths so will only fit the right slot. Although my numberplate lights were a very tight fit and had to bend the contacts slightly. Also when I installed the wing mirror lights they caused a voltage error and only flashed once instead of staying on. This is a resistance problem which can be overcome by soldering in a resistor. Havent done this yet although there is a guide on here somewhere.
Last edited by
Rob5 on Sat Jan 11, 2014 5:34 pm, edited 1 time in total.
